MX29GL320EBTI-70G

MX29GL320EBTI-70G is Macronix’s 32-Mbit parallel NOR Flash memory with a 70 ns speed grade. Key points:
- Capacity/organization: 32 Mbit total (about 4 Mbytes) with an 8‑bit data bus.
- Interface: parallel NOR flash, non-volatile, random-access read.
- Voltage: typically 3.0 V (range 2.7–3.6 V).
- Features: standard NOR flash command set; supports byte/word program, sector/block erase (typical block sizes vary by device), and chip erase; status/ready indication; hardware protection options.
- Endurance/retention: typically around 100k program/erase cycles with long data retention (years).
- Package: available in the EBTI packaging variant (as indicated by the suffix).
- Applications: firmware/boot code storage, code execution in place (XIP) in embedded systems or any area needing reliable non-volatile code data storage.
- datasheet: consult for exact block sizes, command sequences, timing, and reliability specs.
If you need exact block sizes, voltage tolerances, or command set specifics, I recommend checking the Macronix MX29GL320EBTI-70G datasheet.

MX29GL320EBTI-70G is a 32-Mbit NOR flash memory. Key features include:
- Capacity: 32 Mbit; NOR flash with x8 data width
- Supply: 3.0V (2.7–3.6V acceptable)
- Speed: 70 ns read access time
- Banks/Organization: two banks for multi-bank operation
- Erase/Program: sector erase (typically 4 KB sectors); page program up to 256 bytes
- Endurance: typical program/erase cycles around 100k
- Power modes: deep power-down and low-power standby
- Temperature: operation from -40°C to +85°C (industrial)
- Interface: asynchronous, standard flash command set with ready/busy signals
- Protection: hardware write protection and block protection features
- Packaging: EB TI package variant
Note: exact sector sizes, timing, and protective features can vary by revision; consult the datasheet for precise specs.

TSOP-II (8-pin) package.

- Pin count: 8 pins (8-SOIC/8-SOP package)
- Function: 32-Mbit serial SPI NOR flash memory (non-volatile storage; 70 ns access). Interfaces via SPI: CS, CLK, MOSI (DI), MISO (DO), with WP#, HOLD#, VCC, GND. Used for firmware/data storage.

- Manufacturer: Macronix International Co., Ltd. (MXIC)
- Company type: Taiwan-based semiconductor company that designs and manufactures non-volatile memory products (NOR/NAND flash, ROM) and related memory solutions.

MX29GL320EBTI-70G is a 32‑Mbit NOR flash memory. Typical application areas:
- Embedded systems (firmware storage, boot code)
- Automotive electronics (ECUs, in‑vehicle devices)
- Industrial control and automation equipment
- Consumer electronics (set‑top boxes, digital cameras, printers, AV devices)
- Networking/telecom gear (routers, gateways, switches)
- Medical devices needing reliable firmware/data storage
- Any system requiring non‑volatile, high‑reliability code and data storage

Common equivalents (32 Mb, 70 ns, parallel NOR, 48‑pin TSOP II) are:
- Spansion S29GL032F (and variants)
- Winbond W29GL032G (also W29GL032F)
These are pin-compatible with MX29GL320EBTI-70G. Always verify exact package, voltage, and speed suffix from a distributor cross-reference (e.g., Digi-Key, Mouser) for your exact lot.